|
|
 
DRAWWORKS
Main:
UNIT U-34B Single Drum Drawworks, LEBUS Grooved f/1-1/8” Line, Makeup & Breakout Catheads, 15” Double Hydromatic Brake, Single-Engine Drive p/b DETROIT 12V-71 Diesel Engine, w/Electric Starter, Radiator, TWIN DISC F11524 Torque Converter, QUINCY Air Compressor, New Rotary Clutch – 14CB140, Replaced Clutches w/Twin Disc, Low Drum – PO224, High Drum – PO218, Replaced and Refurbished Catshaft & Bearings.
BackUp:
UNIT U-34B Single Drum Drawworks, Skidded, Space For 2 Motors & Compound, Single Draw Lebus, Grooved for 1” Line, MU & BO Catheads, 15” Double Hydromatic Brake, Friction Clutch Pads, High & Low Drum, Oiler System, Control Panel
MAST
Main:
106’ h Butler Parks Double Jack Knife Cantilever Mast, 256,000# Hook Load, 12’ A-Leg spread, Pin-Type, Recent overhauled Crown Block w/(5) Sheaves f/1-1/8” Line, 4” Standpipe, Crown Safety Platform, Racking Board, Tong Counterweights, Ladder, Derrick Climber, Boom, Mast Stand, Standpipe Manifold, Tandem Axle Derrick Dolly
BackUp:
106’ h LEE C. MOORE Double Jack Knife Cantilever Mast (w/Bolted Center-Section Add-On), w/o Crown Block
SUBSTRUCTURE
10’ H x 26’ W x 42’ L Box-Type Substructure w/Rotary Beams, V-Door Ramp, Stairs, Safety Rails, Doghouse Supports, QUINCY Air Compressor, Back-On Ramp
GENERATOR
(2) CAT 100 Kw Generator Set p/b CAT 3304 Diesel Engine, Mounted on Covered Skid w/Day Tank, 4’ x 3’ x 7’ 4-Compartment Lubester.
MUD PUMPS
Main Pump:
EWECO 15W600 Duplex Mud Pump, 600-HP, 7” x 15”, Forged Steel Fluid End w/Threaded Caps, SUMLAR 20-A-5000 Pulsation Dampener, Suction Screen, OTECO 2” Shear Relief Valve, V-Belts w/Guard, Suction Line, Suction Line Boom, p/b CAT D-353 Diesel Engine w/Air Starter, Radiator, Gauges, Air Clutch, Skidded
BackUp1 Pump:
IDEAL C-250 Duplex Mud Pump, 270 HP, 7” x 15”, Forged Steel Fluid End w/Threaded Caps, Surge Chamber, Suction Screen, OTECO 2” Shear Relief Valve, Type D Mud Gauge, V-Belts w/Guard, Suction Line, Suction Line Boom p/b DETROIT Twin 6-71 Diesel Engines, w/Air Starter, Radiator, Gauges, GM Power Transfer Gear, Skidded
BackUp2 Pump:
OILWELL HD 214 Duplex Mud Pump, 6” x 15”, Bolt on Caps, Parts Box, needs overhaul
SWIVEL
Main:
150 Ton HOWARD TURNER Swivel
BackUp:
EMSCO AE-4 Swivel (Recent Overhaul, Including Gooseneck & Bail, never used)
RIG HOUSES
Main:
7’ W x 20’ L Top Doghouse w/V-Top, 4’ L Porch, Knowledge Box, Bench Storage, Cabinets, Fluorescent Lights, Skidded, Electric Heater, Gas Heater
7’ x 23’ L Bottom Doghouse w/V-Top, Lockers, Bench Storage, Incandescent Lights, Skidded, Propane Heat box
BackUp:
7’ W x 20’ L Doghouse w/Flat-Top, Bench Storage, Cabinets, Skidded
ROTARY TABLE
Main:
HOWARD TURNER ZP-175 17-1/2” X 44” Rotary Table w/Split Master
BackUp:
OILWELL 17-1/2” Rotary Table w/Split Master Bushings w/ New Main Shaft & Bearing, Main Bearing, Bearing Race, never used
TRAVELING EQUIPMENT
5-1/4” x 40’ L Square Kelly
BAASH-ROSS-Type Kelly Drive Bushing
Upper Kelly Valve
IDECO Block w/ (4) Sheaves, BJ 4125 Hook
(2) 3” x Approximately 96” Elevator Links
DRILL PIPE/COLLARS
6,500’ of 4-1/2”, 16.60#, Range 2 Drill Pipe w/4-1/2” XH, BN Tool Joints
(22) 6” OD x 30’ L Drill Collars
(4) 6-1/2” OD x 30’ L Drill Collars
BLOWOUT PREVENTOR
Main:
DORLAND – Type 8” 3000# Annular BOP
BackUp:
Shaffer BOP 11” 3000# Annular BOP w/4½ Blinds & Rams
Hydril Accumulator D-80 5,000# BOP
MUD EQUIPMENT
5’ W x 6’ H x 7’ L Mud Mixing Tank w/V-Bottom, Mud Hopper, Skidded
HARRISBURG Single, Single-Screen Vibrating Shale Shaker p/b Electric Motor
WATER/FUEL TANKS
10’ Dia. x 32’ L Water Tank, Skidded
7’ Dia. x Approximately 16’ L Fuel Tank, Skidded
HANDLING TOOLS
WOOLLEY Type C Rotary Tongs
WOOLLEY 4-1/2” BN CL Drill Pipe Elevators
BJ Square Shoulder Side Door Elevators
WOOLLEY 4-1/2” Drill Pipe Slips
VARCO 9-Segment Drill Collar Slips
WOOLLEY 11-Segment Drill Collar Slips
(9) Drill Collar Lift Subs
AUXILIARY EQUIPMENT
3-1/2” x Approximately 50’ L Rotary Hose
3-1/2” x Approximately 30’ L Vibrator Hose
42” H x 5’ W x 50’ L 2-Section Steel Catwalk
(3) 36” H x 7’ W x 33’ L Pipe Baskets
(4) 42” H x 28’ L Triangular Pipe Racks
Fluorescent Rig Light & Wiring
Approximately 5000’ of 1-1/8” Drill Line w/Spool, Stand
Wireline Machine 6,000’ .006 ga. wire w/10 HP elec. motor w/rheostat and variable control, stand mounted w/lift eye
Assorted Hand Tools, Rig Parts/Spares, Fire Extinguishers, Etc.
 
 
 
 
 
 
|
